Reversing light for Citröen AMI - Opel Rocks-e - Fiat Topolino

Set includes :
- 2 LED lights (position, stop, reverse)
- 2 self-adhesive reflectors 56x25 mm
- 1 DNR or RND transmitter module
- 1 reversing light activation module
- 1 m cable for connection between the two lights
- 10 cable clamps for securing cable and activation module to structure
- waterproof connector interposed between driver-side brake light connector
- sheathed cable outlets for reversing camera

Installation:
These lights replace and fit in place of existing lights.
The transmitter module is installed in parallel with the DNR or RND buttons (D - Forward, N - Neutral, R - Reverse).
For DNR buttons located to the left of the driver's seat, the transmitter module is housed in the space beneath the buttons.
For RND buttons located on the dashboard, the cables and module are housed in the free space in the dashboard below the steering wheel.
- The activation module is attached to the metal structure using two cable ties supplied with the unit.
A special wiring harness is fitted between the driver's side brake light, enabling the power supply to be taken over.
- To comply with legislation, the 2 reflectors must be positioned at a minimum height of 35 cm from the ground and a maximum of 90 cm. They must be spaced at least 40 cm apart.

There are no wires to run between the modules. Modules are wirelessly linked by radio frequency.
The modules are self-powered by the existing wiring.
The reversing light is activated by reverse gear detection in the activation module.